The stainless steel knife no. 32 is the part that actually cuts the meat in the mincer: it is fitted on the feed screw shaft, directly against the plate, and cuts the meat as it is pushed through the plate holes. It is made for FIMAR no. 32 meat mincers and fits professional size 32 Enterprise system mincers from Fama, Reber, Tre Spade, KBS, ADE, Caso or Porkert. The product code is COL32I. A blunt knife no longer cuts: it crushes and heats the meat, and the mincer clogs and struggles; a new knife immediately restores the output and the clean look of the minced meat.
Clean and even cutting
The knife is made of stainless steel, with 4 cross-shaped blades and a 15 mm square centre hole that sits firmly on the feed screw shaft. Each blade has a ground cutting edge on the side facing the plate. During operation, the knife rotates against the plate and cuts the meat steadily, without tearing it or turning it into paste. INOX, 32 (the size) and 15 (the hole side) are marked directly on the knife, so the part is easy to identify when you reorder.
Why choose this original knife?
Unlike generic knives, this stainless steel knife has precisely ground blades and sits perfectly on no. 32 plates, which makes it suitable for:
Butcher shops and delis: even mince for kebabs, sausages and cold cuts, day after day.
Restaurants and fast-food outlets: freshly minced meat for burgers, meatballs and sauces.
Supermarkets with a meat counter: continuous work, without heating or crushing the meat.
Production kitchens: withstands frequent washing and constant contact with food.
Technical and Functional Advantages:
Stainless steel: does not rust and is suitable for food contact.
4 cross blades: fast and even cutting at every turn of the feed screw.
15 mm square hole: secure fit on the feed screw shaft, without play.
Standard size no. 32: matches the plates and feed screws of mincers of the same size.
Specifications at a glance:
Product type: Knife for no. 32 meat mincer
Product code: COL32I
Compatible with: FIMAR 32RS, TS32, TI32 and other no. 32 Enterprise type mincers
Material: stainless steel
Number of blades: 4
Centre hole: square, 15 mm
Easy to use
Before ordering, check the size of the mincer (no. 32) and the square hole size of the old knife. Switch the mincer off and unplug it before dismantling. Unscrew the front ring, remove the plate and the worn knife, then fit the new knife on the feed screw shaft, with the cutting edges facing the plate, and tighten the ring without excessive force. After fitting, start the mincer and check that the mince comes out evenly. The knife has 4 blades and a 15 mm square centre hole.
Easy to clean
The stainless steel knife is easy to clean after each use: remove it, wash it with warm water and a mild detergent, rinse it and dry it well before storage. Use a soft brush for meat residues between the blades and avoid aggressive chemicals or abrasive sponges, which can blunt the cutting edges.
Features and advantages of the stainless steel knife no. 32 for meat mincers
✓ Stainless steel, with the INOX marking on the knife
✓ 4 cross blades with ground cutting edges
✓ 15 mm square centre hole
✓ Standard size no. 32, for FIMAR and other Enterprise type mincers
✓ Quick to fit, no special tools needed
✓ Original Italian product