The Metalflex HD505 505BK401 pressure switch, Empero code M.ELK-MUH-001, is the sensor that monitors the water level in Empero commercial dishwashers, both on the EMP.1000 hood type models and on the EMP.500 front loading models. It stops tank filling at the correct level and allows the heating to start only when there is water. A faulty pressure switch leads to continuous filling, the machine stopping during the filling stage or the tank heating element burning out.
Precise water level control
The pressure switch has a round engineering plastic housing with a pressure-sensitive diaphragm and a side connector for the signal hose. As the water rises in the tank, the air in the air chamber (air lock) is compressed, the diaphragm moves and the contacts switch the filling circuit. The contacts are faston type, with a switching capacity of 16(4) A at 250 V, and the T85 marking shows a maximum working temperature of 85°C.
Why choose this original pressure switch?
Unlike generic parts, the original pressure switch has its switching levels factory-set for Empero machines, which makes it suitable for:
Empero EMP.1000 hood type dishwashers: correct tank filling at every start.
Empero EMP.500 front loading dishwashers: the same pressure switch, the same wiring.
Protection of the tank heating element: heating starts only when the water is at level.
Catering equipment service: quick diagnosis and replacement, with no extra adjustment.
Technical and Functional Advantages:
Reliable switching: 16(4) A contacts at 250 V.
Heat resistant: maximum working temperature of 85°C (T85).
Simple fitting: faston terminals and a single pressure connector.
European quality: Metalflex pressure switch, widely used in the household appliance industry.
Specifications at a glance:
Product type: Pressure switch (water level sensor) for dishwasher
EMPERO code: M.ELK-MUH-001
Part code: Metalflex HD505 505BK401
Compatible with: Empero EMP.1000, EMP.500
Switching capacity: 16(4) A / 250 V
Maximum temperature: 85°C (T85)
Connections: faston terminals, side hose connector
Easy to use
Before ordering, check the markings on the old pressure switch (HD505, 505BK401) and the machine model. Disconnect the machine from the power supply. Photograph or note the order of the wires on the terminals, then move them to the new pressure switch in the same position. The signal hose must be clean, with no water inside and no kinks. Fitting must be carried out by an authorised technician; finally, run a filling cycle and check that the water stops at the correct level.
Easy to clean
The pressure switch needs no internal cleaning. During servicing, check the signal hose and the pressure switch connector: if they are clogged with limescale or residues, remove the hose, clean it with warm water and let it dry before refitting. Wipe the outside with a dry cloth, with the machine switched off; do not use pressurised water or aggressive chemicals.
Features and advantages of the Metalflex HD505 pressure switch for Empero
✓ Original part, Empero code M.ELK-MUH-001
✓ Metalflex HD505 505BK401 pressure switch
✓ 16(4) A / 250 V faston contacts
✓ Maximum working temperature 85°C
✓ Compatible with Empero EMP.1000 hood type and EMP.500 front loading machines